How do I start VCS when one node is down?

View previous topic View next topic Go down

How do I start VCS when one node is down?

Post by suran on Sat Apr 12, 2008 6:25 am

· Normally, VCS has to seed all the nodes in your cluster before becoming fully operational.
· VCS may actually startup, but none of the commands will work.
· If one of your nodes is down, and you need to start VCS on the other nodes, then you must manually seed the other node(s).


Run this command on each node that is up:

/sbin/gabconfig –cx

VCS should then be starting up. You may have to online some Service Groups manually:

hagrp -online {Service Group} -sys {hostname}

If the gabconfig command doesn't work, reconfigure GAB and LLT and try again.

Do the following on both nodes:

1. Make sure had and hashadow are not in the process table. Check "ps -ef" and kill them if you have to.

2. /sbin/gabconfig -U

3. /sbin/lltconfig -U (answer yes)

4. /sbin/lltconfig -c

5. /sbin/gabconfig -cx

6. hastart

VCS should then startup on each node that is up.

Thanks to Sarb Panesar for providing us with this article.

suran

Posts : 15
Join date : 2008-04-10

View user profile

Back to top Go down

View previous topic View next topic Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum